12/17/2023 0 Comments Flat steel boningYou can also simply hold the casing in place adjusting as you sew if you don’t want to pin. Therefore, if you prefer you can always pin one at a time, and then sew, so you don’t have to worry about all of the pins. I have to admit that doing this all at once can make for a prickly experience when sewing. This was mostly because my dog was sitting on my lap and didn’t want to move. I decided to pin all of my casings at once. It takes some time to make sure the casings lay flat over very curved sections. That way all of the boning seams are on hidden on the lining and are not visible on the outside of the bodice. This is done on the wrong side of the lining fabric, the canvas. Next, I pinned the casings over each seam. This way they would be slightly wider than my seam allowances.Īfter cutting them into strips I have plenty of casings. I drew my casings 1 1/8 inches (or 9/8 inch) wide. This is at a 45 degree angle to the grainline. Since many of the seams are curved you want to make sure the casings can stretch. I will be making my own using the same duck canvas I used for my lining. You can also buy boning casing separately. If you are purchasing your boning you will notice that some types of boning comes in the casing already. You can always add more than that depending on how structured you want your bodice. The most common places to add bones are along the seams and at the center back. You need to have a channel for the bones to slide into. The first thing you need in order to add boning to a bodice, are casings.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |